CRDBAG 1/4" D-Ring Camera Screw 4-Pack

CRDBAG 1/4"-20 D-Ring Camera Screw (4-Pack) – secure mounting with tool-free tightening

This 4-pack of CRDBAG D-Ring camera screws is a small upgrade that speeds up every rig change. You get four standard 1/4"-20 male screws with built-in rotating D-rings. Tighten them by hand in seconds, then fold the ring flat. No loose Allen keys. No coin tricks. Just a clean, reliable fastener that stays friendly to your workflow.

Use them to lock a camera onto a plate, attach an accessory to a cage, or add tie points to a cart. The integrated D-ring gives you leverage when you need it. The fold-flat design keeps profiles low when you do not. If you build kits that travel, you will appreciate how little they snag. If you work on set, you will appreciate how fast they swap.

Why D-ring screws belong in every kit

Camera support systems get rebuilt constantly. That is normal in video, photo, and field work. What is not normal is wasting time on tiny tools. These screws are made to remove friction from the routine. Spin them in quickly. Fine-tune tension with the ring. Fold it down and keep moving.

Stainless steel construction adds confidence under load. It also holds up well in daily handling. Use them for your “always mounted” accessories. Use them as quick-release points for straps and small add-ons. Keep a few on your cart, and a few in the case. The goal is simple: fewer delays, fewer missing tools.

Built for carts, cages, plates, and modular organization

The screws are designed for common mounting scenarios. They are a natural fit for equipment carts and cheese plates. CRDBAG lists compatibility with cheese plates from Innovativ, Magliner, Yaeger, Backstage Equipment, Filmtools, and Matthews Studio Equipment. That covers a wide range of professional cart ecosystems.

They also pair nicely with modular accessories. Add a secure anchor point for small pouches or light retention. If you run CRDPOUCHES, these screws can help create stable attachment points where you need them. The ring rotates, so you can align it for the cleanest strap direction. Then you can fold it down to keep the surface smooth.

Simple setup

Mounting steps

1. Thread the 1/4"-20 screw into the mounting point by hand.
2. Use the D-ring to apply final tightening without tools.
3. Rotate the ring to a preferred orientation if needed.
4. Fold the ring flat to reduce snagging and bulk.

These steps stay the same across cages, plates, and cart hardware. It is a predictable process that helps keep team setups consistent. It also helps when you need to repack in low light.

Basic technical data

Below are the key specifications for inventory, compatibility checks, and kit planning.

Where it shines

Keep these screws in the places where speed matters. Mount a monitor arm on a cage. Add an anchor point on a cart for straps. Secure a camera plate with confident hand torque. When a job requires frequent changes, these screws pay for themselves quickly.

Notes for long-term use

Avoid over-tightening into soft threads. Keep sand and grit away from moving parts. If the screw gets wet, wipe and air dry. Fold the ring down before packing to reduce wear. This preserves smooth motion and keeps your kit tidy.

Quick FAQ

Is this a standard camera thread?

Yes. The screw uses a standard 1/4"-20 male thread, common in camera gear.

Do I need tools to tighten it?

No. The built-in D-ring is made for tool-free tightening. You can apply final torque by hand.

Will the ring snag inside a bag?

It is designed to fold flat after tightening. That reduces snagging and keeps the profile low.